-62%
Robotics and Science Kits, Sensors And Modules
Red Sound Detection Sensor Module for Arduino/RPi/Other Microcontrollers
Availability:
100 in stock
- Uses LM393, Electret condenser microphone
- Signal output Indication
- Single-channel signal output
- The output effective signal is low level.
- Can detect the intensity of the sound environment
- With the retaining bolt hole, convenient installation.
₹ 38.00 ₹ 99.00
100 in stock
- Sound Detection Module Sensor for Intelligent Vehicle Compatible With Arduino is a Single channel signal output Sensor.
- The output is effective to the low-level sound signal with good fidelity, When there is sound, outputs low level and signal light.
- It can be used for Acoustic control light, give sound and light alarm working with the Photosensitive sensor, and sound control, sound detect. (The Maximum induction distance is 0.5M)
- Note: This sensor only recognizes the availability of sound (vibration principle) cannot identify the size of the sound or the specific frequencies of sound.
Based on 0 reviews
Be the first to review “Red Sound Detection Sensor Module for Arduino/RPi/Other Microcontrollers”
Related products
-
Robotics and Science Kits, Sensors And Modules
1 Pc Sim 800L GSM – GPRS Module is low cost, low form factor GSM module based on Simcoms SIM800L chipset. Sim800L module supports quad-band GSM and GPRS network
Robotics and Science Kits, Sensors And Modules1 Pc Sim 800L GSM – GPRS Module is low cost, low form factor GSM module based on Simcoms SIM800L chipset. Sim800L module supports quad-band GSM and GPRS network
- GSM (Global System for Mobile Communications) and GPRS (General Packet Radio Service) technologies
- Quad-band operation for compatibility across multiple GSM frequency bands
- Supports making and receiving phone calls
- Enables sending and receiving SMS messages
- TCP/IP and HTTP support for internet connectivity
- SIM card slot for standard SIM card insertion
- Controlled using AT commands
- Interface via UART (Universal Asynchronous Receiver/Transmitter)
SKU: 1 Pc Sim 800L GSM - GPRS Module -
Robotics and Science Kits, Sensors And Modules
1 Pc HC-05 Wireless Bluetooth RF Transceiver Module Serial 6 Pin Bluetooth Module Wireless Serial Port Communication BT Module for Arduino
Robotics and Science Kits, Sensors And Modules1 Pc HC-05 Wireless Bluetooth RF Transceiver Module Serial 6 Pin Bluetooth Module Wireless Serial Port Communication BT Module for Arduino
- Communication Protocol: Bluetooth Serial Port Profile (SPP)
- Operational Range: Up to approximately 10 meters (33 feet)
- Interface: UART (Universal Asynchronous Receiver/Transmitter)
- Power Supply: 3.3V to 5V DC
- Pin Configuration: VCC, GND, TX, RX, EN, STATE
- Modes of Operation: AT Mode, Communication Mode
- AT Commands: Configurable settings using AT commands
- LED Indicators: Displaying power, pairing, and data transmission status
- Pairing and Security: Supports pairing and security features
SKU: 1 Pc HC-05 Bluetooth Module -
Arduino Board, Robotics and Science Kits
Arduino UNO with UNO Cable R3 SMD Atmega328P Compatible Development Board With 1 Feet USB Cable for Electronics Components and Robotics Project
Arduino Board, Robotics and Science KitsArduino UNO with UNO Cable R3 SMD Atmega328P Compatible Development Board With 1 Feet USB Cable for Electronics Components and Robotics Project
- Microcontroller: Atmega328P
- Digital I/O Pins: 14
- Analog Input Pins: 6
- PWM Pins: 6
- USB Interface: Type-B connector
- Power Options: USB or external DC power (7-12V)
- Voltage Regulator: Provides stable 5V supply
- Reset Button: For restarting or resetting the board
- ICSP Header: In-Circuit Serial Programming for advanced users
- Compatibility: Works with various sensors, shields, and modules
- Open-Source Software: Arduino IDE for programming
- User-friendly and suitable for beginners and hobbyists
- Affordable and widely used for electronics and programming projects.
SKU: 1 PC Arduino UNO With Cable -
Robotics and Science Kits
Mini Bulb Holder kit for Simple Electric Circuit Kit Science Project Working Model with Mini Bulb Experiment kit
Robotics and Science KitsMini Bulb Holder kit for Simple Electric Circuit Kit Science Project Working Model with Mini Bulb Experiment kit
- Parts Include – Mini Toy Holder, Toy Bulb, 9V Battery, Connector, Connecting Wire, On Off Switch
- Battery provides electrical energy
- Switch controls the flow of electricity
- Closing the switch completes the circuit
- Current flows through the mini bulb filament
- Applications discussion for real-world relevance
SKU: Mini Toy Holder Bulb Kit
There are no reviews yet.